Installation & Assembly Problems
447 problems reported across 10+ industries
Industries Reporting Installation & Assembly Problems
Top App Ideas for Installation & Assembly
View allGuttrCheck AR
Gutter Slope Verification via AR
AlignPro Electrical Planner
Box & Conduit Alignment for Installation
FlashingPro Guide
Flashing Installation Guidance for Roofers
FitLink Pro
Tight space plumbing connection app
ValveFit
Easy pipe fitting tool for tight spaces
PEX Pro Guide
PEX Connection Confidence App
Installation & Assembly Problems(page 20 of 23)
FitCheck Pro
A new 1.5" P-trap is slightly too wide to thread onto the existing drain elbow, causing a fit issue during replacement.
ExhaustHang Pro
Need advice on installing an exhaust hanger in a tight space where the exhaust rotates to the right and there is limited room on the left side.
PlumbCheck PRO
A tenant/DIYer needs guidance on proper sink plumbing configuration for a three-bay sink but lacks expert knowledge or code familiarity.
RoofVent Seal Guide
Uncertainty about whether sealing the gap between ridge vent and shingles is common practice, despite manufacturer recommendations.
RoofEdge Pro
First-time roofer lacks guidance on finishing drip edge at a flying rake end, causing unsatisfactory results.
PlumbCheck
Unsure if a pipe protruding above a flange is acceptable and needs a fix
ConduitBend Pro
A worker needs guidance on how to properly bend EMT conduit to navigate an outside corner and transition upward for a new light installation.
GutterGuide Pro
Gutter termination distance at roof elevation changes is unclear, leading to water management issues.
PlumbGuide Pro
Uncertainty about the best material and method to create a bypass loop for a water softener installation.
WallPort Pro
Mobile car detailer needs to convert a fixed ice maker outlet box into a multi-port water supply for a wall-mounted pressure washer, hose bib, and garden hose.
HVAC Install Guide
Outdoor heat pump installation requires elevation above expected snow level and supply plenum insulation, but there is no specific software to help plan or document these requirements.
TrimCheck Pro
New build shower control trim ring has a visible gap against tile, causing aesthetic and moisture concerns despite builder's assurance of waterproofing.
VentFit Slim
Homeowner needs to fit a vent pipe within a standard 2x6 wall cavity without excessive bulk or visible intrusion.
GutterFit Guide
Gutter installer struggles with fitting gutters tightly against drip edge due to incompatible gutter design.
TorqueTight Pro
Plumber experiences uncertainty about proper tightening torque for stainless steel flex hoses on water heater connections, leading to leaks and risk of overtightening.
PipePlanner Pro
Figuring out how to correctly discharge a condensate pump into a new plumbing configuration without causing code violations or future issues.
BoxPlanner Pro
Electricians need to decide whether to install separate or combined electrical boxes for devices near each other to avoid messy installations.
InstaSpec Pro
Worker wonders whether expansion joints are required for an installation, but lacks confidence in interpreting manufacturer guidelines to make the decision.
RoofVent Pro
Uncertainty about the correct installation of dry ridge system, specifically the required gap near the ridge beam for ventilation.
GutterSlope Pro
Struggling to achieve proper slope on DIY gutter inside corners, resulting in standing water.